Product: Instant Digital Download (PDF)
Diagnose BYD ATTO 3 / Yuan Plus front drive motor overcurrent, current-sensing and missing-phase faults using OEM diagnostic procedures for fault-code confirmation, controller diagnosis, three-phase resistance comparison and drive-motor insulation testing.
Years Covered:
2022, 2023, 2024, 2025
Vehicle Specification:
SC2E, e-Platform 3.0 400V, FWD, RHD
Excludes:
2026+ BYD ATTO 3 Evo, 800V RWD/AWD architecture, 74.8 kWh Cell-to-Body battery pack, and Left-Hand Drive (LHD) variants.
DTCs Covered
- P1BB000 — Front Drive Motor Overcurrent
- P1BC900 — Front Drive Motor Controller Current Hall Sensor A Fault
- P1BC500 — Front Drive Motor Controller Current Hall Sensor B Fault
- P1BC600 — Front Drive Motor Controller Current Hall Sensor C Fault
- P1BC200 — Missing Phase A in Front Drive Motor
- P1BC300 — Missing Phase B in Front Drive Motor
- P1BC400 — Missing Phase C in Front Drive Motor
Diagnostic Coverage
- OEM high-voltage and electrical/control-module precautions
- More than 5-minute high-voltage capacitor-discharge requirement where applicable
- VDS front motor controller fault-code confirmation, clearing and recheck
- OEM intermittent-fault diagnostic procedure
- P1BB000 front drive motor overcurrent diagnosis
- Three-phase peak-current fault condition
- Vehicle OK gear verification
- Integrated intelligent front-wheel drive controller replacement and power-domain-controller recheck
- P1BC900 Hall Sensor A fault diagnosis
- P1BC500 Hall Sensor B fault diagnosis
- P1BC600 Hall Sensor C fault diagnosis
- Controller software update and identical-DTC recheck
- P1BC200 Phase A loss diagnosis
- P1BC300 Phase B loss diagnosis
- P1BC400 Phase C loss diagnosis
- Front drive motor three-phase wiring disconnection
- Three-phase resistance comparison
- Greater than 1 Ω pairwise resistance-difference decision criterion
- Front drive motor insulation-resistance testing using a megohmmeter
- Positive terminal-to-ground insulation test
- Negative terminal-to-ground insulation test
- Greater than 2 MΩ motor insulation criterion
- Insulating-glove requirement for motor insulation testing
- OEM PASS/FAIL and guided diagnostic decision paths
- OEM-directed front motor controller, integrated intelligent front-wheel drive controller and drive motor assembly replacement actions
Included Links to OEM Source Material
Reference links are provided within the guide for:
- Complete OEM Diagnostic Manual
- Electronic Wiring Diagram
- Repair Manual
The linked OEM source documents are separate reference resources and are not included with this Diagnostic Guide.